There are 43 products.
Connection hose for use with professional, standard or inflator flow limiters.
It is meant for the cylinder low-pressure connection with the diameter of 5.8 mm..
Professional flow limiter equipped with an automatic reduction valve.
This enables the extraction of gas from the tank at a constant flow rate, independent of the pressure in the cylinder.
The standard limiter works on the principle of a throttle nozzle. Its flow is therefore dependent on the tank pressure. T
he greater the pressure, the greater the flow is. Therefore, it is suitable for divers to check the mixture before the actual dive.
The flow limiter with connection to the DIN - G 5/8" for 200 and 300 bars, with needle valve. The connection hose is not included.
Gas flow depends on the inlet pressure.
Doivesoft He/O2 analyzer is a precise apparatus for measuring oxygen helium concentrations in diving breathing gasses. It is a necessary tool for technical divers using nitrox and trimix mixtures.
Professional Set Blender Basic was compiled for divers and mainly for filling stations, which prepare Nitrox and Trimix and which want to have analyzer stored in the watertight Peli case 1200.
Set Blender Basic contains professional flow limiter.
Professional Set Blender Max was compiled for divers and filling stations, which prepare Nitrox and Trimix gas mixtures.
The analyzer can measure resistance and voltage and can be stored in the supplied waterproof Peli Case 1200.
Set Blender Max contains professional flow limiter.
Analyzer SOLO is a precise apparatus for measuring oxygen and helium concentrations in scuba diving breathing gasses. It is a necessary tool for technical divers using nitrox and trimix mixtures.
A smart and accurate NITROX analyzer that offers simple oxygen measurement and advanced features.
Analyzer SOLO O2 is the ideal partner for all recreational NITROX divers.
Analyzing is really easy, just turn on with one press and measure. Easy automatic calibration. Analyzer SOLO O2 has the same durable polymer body as its brother Analyzer SOLO, allowing you to upgrade to a trimix analyzer by adding a helium sensor*.
This bottom timer was specially developed in order to meet the needs of technical divers using ratio deco for decompression calculations.
Decompression Freedom computer for advanced divers who use the principles of an accelerated decompression. The computers allows for the use of up to three mixtures, ranging from air to pure oxygen.
Freedom computer can be used as a nitrox analyzer if an oxygen sensor is attached.
Just order Freedom Nitrox analyzer.
The analyzer is supplied WITHOUT an oxygen sensor.
Use Divesoft R22S oxygen sensor with Molex 3-pin connector or equivalent like our NRC oxygen sensor D05-R
Oxygen sensor previously used in rebreather (type R22-D) can also be used in the probe, if they are still able to measure full range of oxygen pressures in atmospheric pressure safely.
Basic version of the Freedom computer intended for sports divers. The computer has been designed with the most demanding conditions in mind. A decompression calculation is available for air or nitrox with the oxygen volume up to 40%.
The Freedom closed circuit computer is the highest version of the Freedom decompression computers, which apart from the function of the previously mentioned computers also includes the calculation of online decompression for CCR. Freedom can be connected to up to 3 oxygen sensors of your rebreather. For diluent, bailout and open circuit there are up to 9 gas mixtures available, including helium mixtures.
One, two or three O2 sensors can be connected. The average pO2 value can be read on the primary screen and detailed information about each sensor, including sensor voltage, can be accessed via a separate screen. Fixed setpoint and SCR modes for different types of rebreathers are also available.
The O2 cells connection cable is NOT part of the package.
For example: bulbs check, cables check.
After connection to the He/O2 analyzer the measuring of impedance in range of 0 — 1000 ohms is automaticaly switched on.
There is an option to have an acustic signal when the impedance goes under 200 ohms.
With this product we recommend to order measuring cabels #1058.