.
Category: Divesoft – Accessories
.
.
Spare kit of O-rings for DIVESOFT He/O2 Analyzer and jumper for firmware upgrade
Bleed valve consists of bleed valve body, bleed valve screw, o-ring 4x2 NBR70 and stainless steel ball 1/8".
Connection hose for use with professional, standard or inflator flow limiters.
It is meant for the cylinder low-pressure connection with the diameter of 5.8 mm..
Professional flow limiter MK2 G5/8
The Professional flow limiter Mk2 is equipped with a regulator that reduces the gas to flow at a constant rate regardless of the cylinder pressure. This enables the gas sampling to remain accurate even at very low pressures. This feature has proven to be critical during gas blending procedures.
The standard limiter works on the principle of a throttle nozzle. Its flow is therefore dependent on the tank pressure. T
he greater the pressure, the greater the flow is. Therefore, it is suitable for divers to check the mixture before the actual dive.
The flow limiter with connection to the DIN - G 5/8" for 200 and 300 bars, with needle valve. The connection hose is not included.
Gas flow depends on the inlet pressure.
Ohm-meter plug-in.
For example: bulbs check, cables check.
After connection to the He/O2 analyzer the measuring of impedance in range of 0 — 1000 ohms is automaticaly switched on.
There is an option to have an acustic signal when the impedance goes under 200 ohms.
With this product we recommend to order measuring cabels #1058.
Voltmeter plug-in for example: battery check (lights, scooters...).
After connecting to the He/O2 Analyzer it automatically switches itself into measuring mode.
It measures the varying tension up to 28 V (RMS) and the constant tension up to 40 V with polarity indication.
We recommend you to order measuring cord #1058..
Simple connector to the DIN G5/8 valve. The connection is placed into the gas input port of the analyzer and pushed against the tank valve.
Gas flow is regulated using the tank valve. It is suitable for a fast analysis of gas in several tanks. With some valves is may be difficult or even impossible to set a low enough gas flow – in such case use a flow limiter or regulator.
The connection to an inflator hose enables the measuring of mixtures in already dressed tanks without the need of removing the second stage regulators.
You only need to disconect an inflator or other quick release connector, which will output a flow of 0.2 l/min at 10 bar.
The connector is cylindrical with a diameter of 5.8 mm, to the He/O2 analyzer it is connected via a connection hose.
Simple connector to the DIN G5/8 valve. The connection is placed into the gas input port of the analyzer and pushed against the tank valve.
Gas flow is regulated using the tank valve. It is suitable for a fast analysis of gas in several tanks.
With some valves is may be difficult or even impossible to set a low enough gas flow – in such case use a flow limiter or regulator.
Simple flowmeter for checking of the flowing air from a professional or standard limiter. It can also be used for calibration of a standard flow limiter.
The measuring cables for using with ohmmeter and voltmeter.
The stainless ball serves as a valve of the reduction valve in the flow limiter. In a standard flow limiter, the second ball is part of the regulation valve.
There are 5 pcs in one package, price is per the whole package.